Elo Serial Touchscreen

yeah, i've been using the ELO "entuitive" serial touch (and their USB
touch) for quite a while just using the Serial SLD from the ELO site.
The version of the component i have been using is rev 100 dated
5/23/2003. Their dev team has been very responsive to me in the past
when i've had suggestions as well so the experience with this HW has
been very favorable.

--
Andy
This posting is provided "AS IS" with no warranties, and confers no
rights.

OK I've tracked down the exact problem with this component.

The driver I componentised, and at least one of the ones on XPefiles.com,
have a section on the 'General' tab of the Elo control panel in which you
can set the serial port to use. These are the drivers which just go 'beep'.
This is not present on the driver from Elo's site. This is because
*drumroll* it's not supposed to have, it's set to use COM2. I assume this is
something Elo had to do in order to get it to work on XPe. I had it on COM1,
hence not working. The fact that it's using COM2 is there for all to see on
the diagnostics tab, but did I think to look there, oh no. *bangs head on
desk*.


"Andy Allred [MS]" <andyall@online.microsoft.com> wrote in message
news:uWRyMOolEHA.2492@TK2MSFTNGP15.phx.gbl...

> yeah, i've been using the ELO "entuitive" serial touch (and their USB
> touch) for quite a while just using the Serial SLD from the ELO site.
> The version of the component i have been using is rev 100 dated
> 5/23/2003. Their dev team has been very responsive to me in the past
> when i've had suggestions as well so the experience with this HW has
> been very favorable.
>
> --
> Andy
> This posting is provided "AS IS" with no warranties, and confers no
> rights.