IPv6

what I have done is put the following command in the phase 3498
snetcfg -u ms_tcpip6

I have never notice problem with IPV4.
I don't like manual operations, if I wanted to remove ipv6 in
TD, I must do a manual operation. and since adding ipv6 does
not increase too much image size, so I prefer uninstall it at
run time.

HTH

Zirong

"Manoj" <manoj.mehta@med.ge.com> wrote in message
news:1144443274.226075.12780@t31g2000cwb.googlegro ups.com...

> IPv6 gets installed by dafault when using SP2. Which component do I
> have to remove from my TD configuration so that IPv6 is removed but
> IPv4 is retained in the image? Will removing IPv6 have adverse
> consequences on any dependent components used by IPv4? In short, I need
> only IPv4 in my image.
>
> Thanks
>