mirrored hard drive

If your drive controller is not natively supported then you'll want to boot
the Windows XP CD-Rom. Then *F6* very early and very important (at setup is
inspecting your system) in the setup to prevent drive controller detection,
and select S to specify additional drivers. Then later you'll be prompted to
insert the manufacturer supplied Windows XP driver for your drive controller
in drive "A"

If you wait and then S to specify additional drivers, then it may be too
late as Windows XP Setup at this point may have already assigned the
resources your drive's controller is wanting to use.

When you get to the point, delete the existing NTFS and or other partitions
found. After you delete the partition(s) abort the install, then again
restart the pc booting the CD-Rom or setup disks to avoid unexpected drive
letter assignments with your new install.

Be sure to apply SP2 or at least these to your new install before connecting
to any network.
http://www.microsoft.com/downloads/d...displaylang=en

http://www.microsoft.com/technet/sec.../MS03-043.mspx
http://www.microsoft.com/technet/sec.../MS03-049.mspx


--

Regards,

Dave Patrick ....Please no email replies - reply in newsgroup.
Microsoft Certified Professional
Microsoft MVP [Windows]
http://www.microsoft.com/protect

"darrylh" wrote:
|I deleted partitions on two mirrored hard drives. I went to reload an
| operating system and now win xp doesn't recognize hard drives.