Vista and RAID 10 - problem

Posted: 07-05-2008, 10:24 PM

Trutta

Guest
Posts: n/a

Hello,

I have a Vista Home Premium x64 installed on RAID 0+1 Matrix. Some day
I had to reset the system because the system was hang on. After that,
when I start the computer, I see in BIOS message for martix RAID: Status
"Verify" in yellow color(before was "Normal" in green) and the system
load/starts much much slower than before. HDD LED is lighted all the
time on front panel, but the system (after slow start) works OK. What I
have to do to back to "Normal" status from "Verify" status RAID matrix
in BIOS during start the computer.

Thank you in advance,
Best regards
Trutta

Mobo Asus P5K-E, Q6600, OCZ RAM, HDD 4x250GB WD

--
Trutta

Responses to "Vista and RAID 10 - problem"

Kerry Brown

Guest
Posts: n/a

Re: Vista and RAID 10 - problem

Posted: 07-05-2008, 10:46 PM

"Trutta" <guest@unknown-email.com> wrote in message
news:cc18a93a935c7e21e500ca8207e006f6@nntp-gateway.com...

>
> Hello,
>
> I have a Vista Home Premium x64 installed on RAID 0+1 Matrix. Some day
> I had to reset the system because the system was hang on. After that,
> when I start the computer, I see in BIOS message for martix RAID: Status
> "Verify" in yellow color(before was "Normal" in green) and the system
> load/starts much much slower than before. HDD LED is lighted all the
> time on front panel, but the system (after slow start) works OK. What I
> have to do to back to "Normal" status from "Verify" status RAID matrix
> in BIOS during start the computer.
>

One of the drives in the array has failed. You'll have to figure out which
one and replace it. See the documentation for your RAID controller. It may
be that the drive hasn't actually failed. Some consumer drives don't work
that well with RAID. They get a lot of timing errors. Eventually the RAID
controller thinks the drive has a problem because of all the errors and
removes it from the array.

--
Kerry Brown
MS-MVP - Windows Desktop Experience: Systems Administration
http://www.vistahelp.ca/phpBB2/

Trutta

Guest
Posts: n/a

Re: Vista and RAID 10 - problem

Posted: 07-07-2008, 07:30 AM

I installed the newest Intel Matrix Storage Manager and I solved th
problem stressless from Windows level

Th

--
Trutta

LinkBack

Thread Tools

Display Modes

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Promise Fast Track 376/378 Raid Driver Problem installing Vista B2	boomboom	Windows Vista Hardware & Devices	17	12-17-2008 02:24 PM
Raid 5 with Vista Ultimate x64 on non Raid drive... No boot disk detected!	ThaClown	Windows Vista Hardware & Devices	4	03-07-2008 03:32 PM
Vista 64 & Asus A8N-SLI delux + SI 3114 raid problem	Who am I	Windows Vista Hardware & Devices	5	08-27-2007 12:08 AM
Vista x64 dual boot WinXP with RAID-5 ICH8R messes up RAID array	xgraph	Windows Vista Install & Setup	1	02-19-2007 06:25 AM
Vista SLOW - Intel 82801FR RAID Controller Driver Problem?	Jonathan Schmidt	Windows Vista Hardware & Devices	0	07-05-2006 12:41 PM