where to put the Pid

Posted: 12-07-2003, 08:42 PM

Michael Weileder

Guest
Posts: n/a

Hello

I'm searching for about an hour to find the box, where I can put my PID in.
Target Designer creates only eval versions. I haven't found anything in the
help.

Thanks for helping me
Michael

Responses to "where to put the Pid"

Slobodan Brcin

Guest
Posts: n/a

Re: where to put the Pid

Posted: 12-07-2003, 09:29 PM

Middle panel->Settings
Then in right panel you will see "Run-time Image Licensing". Below you will
see Target Device Settings.

If Run-time is not there, then you probably used eval-version. If you have
then you will need to deinstall all utilities and repositories. And to do
new clean install.

Regards,
Slobodan

"Michael Weileder" <m.weileder@its-weileder.de> wrote in message
news:ekZGpKQvDHA.1596@TK2MSFTNGP10.phx.gbl...

> Hello
>
> I'm searching for about an hour to find the box, where I can put my PID

in.

> Target Designer creates only eval versions. I haven't found anything in

the

> help.
>
> Thanks for helping me
> Michael
>
>

LinkBack

Thread Tools

Display Modes

« I can't even install XPE | Login problem »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90